– tick the checkboxes “Move SCN To Home If Detected” and “Move SCN To Center If Detected” (see the screenshot below) – select the correct port COM of your SCN 1 and SCN 2, IMPORTANT: Internal SCN ID must be at 0 (ZERO) – launch it (if app won’t start see HERE) MMXSCNInfo App – The Purpose Of This Tool:ĬHECK IF YOUR SIMULATOR IS COMPATIBLE WITH MOTIONMAX MGR,ĬHECK THE POSITION OF YOUR SCN ACTUATORS AND IDENTIFY THE COM PORTS OF YOUR ACTUATORS, IMPORTANT: we do not do the hardware support of your simulator, if you need assistance contact your hardware supplier. – so you know exactly which COM port is connected to each actuator (Right, Left, TL). – VERY IMPORTANT: you already DOUBLE-CHECKED all your COM Ports using the Windows Devices Manager and set the Timer Latency to 1 ms (see the screenshot above) in the Advanced Options of each Windows COM Ports, – you already connected the USB cables from the COM-Ports unit to your PC (preferably to a DEDICATED USB HUB), – you already connected each actuator to the corresponding COM ports on the COM-Ports interface included with your simulator, – you already installed the driver of your COMUSB interface (RS485USB Converter) included with your simulator, The FTDI driver ( CDM v2.12.28 WHQLCertified ) for Windows 64bit is available HERE ( ), – you already built the 2DOF Machine and follow the mounting instructions to put the 2 or more actuators in the correct position and you assign the internal ID = ZERO to them (ID=0 is a factory default setting so you normally don’t have to worry about the ID of your SCN), – you respected fully the THE HEALTH AND SAFETY PRECAUTIONS INCLUDED WITH YOUR SIMULATOR MACHINE, – you completely read, understood and agreed to the TERMS And Conditions of use of the MotionMax Manager software,
We assume here that ALL THE HARDWARE IS READY TO USE AND THE 2DOF MACHINE CONNECTED TO THE PC, which includes you follow the mounting and wiring instructions from your supplier. IMPORTANT: all SCN actuators of your simulator must have the SAME STROKE 100 mm or 150 mm, you can’t mix stroke.
(with 1 USB 2.0 port available or better with a HUB USB 2.0 with external Power Adapter) Windows OS 64bit up to date 7/8/8.1/10/11Ī gaming PC capable of running a simulation or game at 60 FPS or higher (screen resolution minimum 1600×900) You’re about to install the software MotionMax Manager dedicated to your 2DOF Simulator, System Requirements Getting Started With MotionMax Manager 2DOF Edition
0 kommentar(er)
